Konda Sence replaces clipboard temperature checks with wireless sensors that watch your water system around the clock. They alert you the moment temperatures drift into the legionella risk zone and fill in your L8 logbook automatically.
Fitting takes minutes, with no plumbing changes and no downtime for your water system.
Clamp-on sensors go on your tanks, calorifiers and sentinel outlets, the same points you check by hand today.
Every Node reports wirelessly to the Konda Hub, which sends the data securely to the cloud.
Each reading is checked against HSG274 temperature limits for that outlet type, around the clock.
You get an alert the moment something drifts, and your compliance logbook fills itself in.
Legionella bacteria multiply in water between 20°C and 45°C. Under the HSE's Approved Code of Practice L8, duty holders must control that risk and keep records that prove it.
Most sites still rely on monthly manual checks, which give a snapshot once a month and leave weeks of blind spots in between. Konda Sence monitors continuously, so problems are caught in minutes, not weeks.
A monthly check gives you 12 readings a year. Konda Nodes record thousands of readings a month at every point, so you can see the trend as well as each reading.
The return temperature is slowly falling. Konda projects the trend forward and warns you before it drops below 50°C, while there's still time to service the calorifier.
Konda learns each outlet's normal pattern. When a reading falls outside that pattern, it sends an alert, even if the reading is still within the legal limits.
Under HSG274, outlets that aren't used regularly should be flushed at least weekly. On a large site that means someone walking every corridor and running every tap, which can add up to a full-time salary.
Konda Nodes detect each time water flows through an outlet. Each week you get a short list of the outlets that haven't been used, so you only flush those, and every flush is logged.
These are illustrative figures. They assume weekly flushing, 3 minutes per outlet including walking and recording, £15/hour staff cost, and 12 litres per flush. Your site will vary.
A Hub for each site and a Node at each point you monitor. That's the whole kit.
Collects readings from every Node, shows live temperatures on its built-in display and sends data securely to the Konda cloud.
A rugged wireless sensor with clamp-on probes. Fit one to a pipe, tank or outlet and it starts reporting straight away.
Everything you need to stay in control of your water system and prove it, in one place.
SMS and email alerts the moment a reading leaves the safe range.
Every reading recorded and time-stamped. No clipboards, no gaps.
Compliance reports for auditors, insurers or your water hygiene contractor.
Every building in one place, with status up front and detail on demand.
Spot a failing calorifier or a warming cold supply long before it fails a check.
Spots outlets that haven't been used, so your team skips the rest.
Tell us a little about your buildings and we'll show you how continuous monitoring could replace your manual temperature checks.
